Vertical Cutting Dryer for Waste Management Clients

GN Solids Control has been developing different solids separation equipment for different industries, especially for Oil and Gas where there are applications with very particular components where any separation equipment cannot work, compared to this GN has extensive experience in Solids Control. and Waste Management has successfully developed the Vertical Clippings Dryer for OBM (Oil Based Mud) and SBM (Synthetic Based Mud) workers.

The GN Vertical Dryer uses centrifugal force to dry drilled solids in oil or synthetic base fluids. A stainless steel mesh bowl catches "wet" solids and revs them up to 900 RPM with a 420G G-force. Liquid is forced through the openings in the screen bowl, while "dry" solids are drawn out by the angled stubs attached to the cone, which rotate slightly more slowly than the bowl. Tungsten carbide protects flights from abrasive solids and ensures long life. This helps maintain a consistent gap between the parchment and the screen bowl, which is crucial for proper operation.

Rotor flights are up against HRC 65, a longer life than our competitors.
Flights and rotor assembly are individually balanced for future replacement.
High precision stainless steel screen specially designed to ensure better separation, longer life and easy replacement.
The screen itself is individually balanced for future replacement. And the screen is separated from the frame, which allows you to change the screen only, no need to change the inner frame.

Special high pressure air knife design to clean the basket screen automatically to avoid screen blinding, especially for high viscosity mud and water-based mud.
All around the washing system through a specially designed nozzle to avoid blockage of the liquid discharge channel.
Individual oil lubrication system with automatic alarm for pressure limit. The main motor and the oil pump motor are interlocked with each other to prevent the starting of the main motor before the starting of the oil pump motor.

APPLICATION OF VERTICAL CUT DRYER:

GNCD930 Vertical Cutting Dryer is used to take drilling fluids from drilling cuttings. It is to maximize the recycling of drilling fluids and minimize drilling waste to save cost for operators.
1) For oil-based drilling cuttings, you can normally reduce the oil in the cuttings to 3% to 5%.
2) For waterborne cuts, you can usually reduce the moisture content to very low, which is easier for transport.
3) Recycling of drilling fluids for reuse to save costs.
4) Reduce the amount of drilling waste to save money on disposal or further treatment.